shade

Products

homeProducts

Mechanical Surface Grouting Packer

Mechanical grouting packer in the grouting hole, by mechanical pressure to make the rubber plug (seal) transverse, and the hole wall is tight, the grouting hole is divided into upper and lower two sections, so that the grouting of the lower section can be put into the grout crack water-bearing rock, but not from the rubber plug back to the upper section of the hole, or even the surface, to ensure normal subsection grouting. Grouting refers to the index that should be achieved after the grouting is required by the designer. Because of the different grouting engineering properties and engineering address conditions are different, the purpose and requirements of each grouting are not the same, so it is difficult to provide a more specific and unified criteria, but can only make specific rules according to the specific situation

MAIN SPECIFICATOIN

Packer Type
Rubber length(mm)
Total length(mm)
Nomical Ø
DP27 50 600 1/2" NPT
DP33 50 600 3/4" NPT
DP36 50 600 3/4" NPT
DP38 50 600 3/4" NPT
DP40 50 600 3/4" NPT
DP48 50 600 3/4" NPT
DP55 50 600 3/4" NPT
DP60 100 600 3/4" NPT
DP65 100 650 3/4" NPT
DP73 100 700 1" NPT
DP88 100 700 1" NPT
DP98 100 700 1" NPT
DP108 100 700 1" NPT
DP127 100 700 1" NPT
DP146 100 700 1" NPT




Contact Us

You have a specific question or would you simply like to learn more about us?

Find our contact information below or use our Contact Form.

upward